Expert Shield Anti-Glare Screen Protector for DJI RC 5.5' Controller

The Anti-Glare version of the Expert Shield screen protector for the DJI RC 5.5" controller is a matte version that diffuses light to help you use the controller in sunlight. Expert Shield uses an ultra-hard layer sandwiched within the protector to provide a deep level of protection. The hard layer is designed to stop certain sharper objects from penetrating through to your screen. At the same time, the surface layer absorbs lighter scratches.

The diffusion does reduce optical clarity by 3-5% under normal or indoor lighting conditions, but this is a low reduction. However, if you are planning to control your Mini 3 Pro drone from an indoor or low-lit location, the Expert Shield Crystal Clear version of the protector for the RC 5.5" controller is recommended.

The protector attaches via a silicone gel layer without trapping any air bubbles, and it stays on securely until you want to remove it. To remove it, just use a bit of good-quality sticky tape affixed to one corner. This will allow you to lift off the protector without damaging the corner or your fingernail. Since no glue is used when the protector is attached, there will be no residue left on your screen should you wish to remove the protector. Also, the screen protector is washable and can be saved for later use. To do this, place the gel side down onto the sticky side of some tape, and that will keep any dust away until you re ready to use the screen protector again.

EAN: 643217367162