PRG ReNEW Daylight LED Retrofit Assembly with powerCON Power Cord for ETC

The 5,700K ReNEW Daylight LED Retrofit Assembly with powerCON Power Cord from PRG is an LED light engine designed to work in conjunction with the lens tube and shutter assemblies of the ETC Source ellipsoidal.

Exchanging the tungsten light source of the Source Four with the daylight LED source of the ReNEW Assembly reduces energy consumption and HVAC costs while producing lumen output that exceeds a 575W HPL lamp. The ReNEW light engine draws 190W at full output and just 3.1W during standby.

The assembly is designed around a chip-on-board (COB) LED light source array paired with a specially designed reflector and lens that provides optimal illuminance distribution through the Source Four lens. The COB array is designed for easy future upgrading as improved LEDs become available.

The Source Four reflector and lamp assembly can be replaced in less than a minute with the ReNEW Assembly which is compatible with both ETC standard and Enhanced Definition Lens Tubes (EDLT) and all Source Four accessories. The fixture can be operated with 1, 2, or 3 channels of DMX control, or operated in user-selectable stand-alone mode for simple installations or where DMX is not available. A DMX signal can be connected and passed through the unit via optically isolated male and female flush-mount 5-Pin XLR connections.

The ReNEW Assembly offers 90-240 VAC 50/60 Hz operation via its Neutrik powerCON connection while up to four 4 units may be linked using the thru connector. An additional power connection is available for a 9 VDC battery to operate the control panel for quick setup or for shop preparation without need to connect primary full power to the unit.