MADRIX USB ONE USB DMX I/O Interface

MADRIX IA-HW-001001 Overview

Control a universe of DMX channels using the MADRIX USB ONE, a USB-to-DMX interface designed for use with the MADRIX 5 software. The single cable features a 5-pin XLR Neutrik DMX connector and a USB-A 2.0 connector. The USB ONE is mainly used for DMX input, and an additional MADRIX key (software license) is required for DMX output.

• DMX-In/Out with 5-Pin Neutrik XLR Port: This device allows you to send or receive DMX data using 512 DMX channels. A male-to-male 3-pin or 5-pin XLR Gender Changer is required for DMX-In.
• Hot Swapping and Plug-and-Play: Devices can be connected to and disconnected from the computer during use and without a reboot.
• USB 2.0 Standard: The USB 2.0 standard is fully supported to allow a higher maximum speed of 480 Mb/s.
• Remote Control: MADRIX 5 can be controlled remotely using the implemented DMX-In functions.
• Power-over-USB: The interface is powered directly via the USB port and does not need an additional power supply.
• Frame Rate Stability: Up to 60 devices can be connected to a USB host controller without having any frame rate problems. (60 DMX512 interfaces amount to 30,720 DMX channels.)
• Active USB: Please connect every USB ONE to an active USB 2.0 port or use a USB 2.0 hub with a power supply.