Trijicon Bright & Tough Suppressor Night Sight Set for Smith & Wesson M&P C.O.R.E. Pistols (White Outline Disks)

These are Trijicon sights, top tier sights rightfully made here in America, where they should be. I purchased two sets, one for each of my MP CORE 9mm pistols. I have two gripes about mine: 1. One of the two sets I ordered is out of spec. My experience with stock MP sights is they're very snugly set inside their dovetails, especially the rear sights. This was no different in my MP CORE pistols. It was quite an effort to remove the rear sights, even using my MGM Range Master sight pusher. The rear sight of one set of these new Trijicons effortlessly slid right through my rear dovetail sight post... obviously way too loose. The second set rear sight was a better fit, but still went on way easier than the stock MP rear sight came off. A little bit of loctite blue treadlocker on the rear sight set screw and it was fine. The other rear sight, the one that freely slides right through the rear dovetail slot, should be replaced. needs to make this right. 2. These Trijicon rear sights have a sharp pointed edge at their rear base, which sticks out beyond the top edge of my MP slides. The superior stock SW rear sights were a bit rounded off and fit nicely flush to the tops of my slides. I've not seen this poor level of quality in Trijicon products before. I hope I don't in the future, otherwise I'll stick exclusively with AmeriGlo products.