Kenko LCD Monitor Protection Film for the Canon EOS 7D Mark II Camera

Sorry to give a bad review, but there is something terribly wrong with the adhesive used on one of the tabs used in the installation. The adhesive on the second (top) tab is way too strong for the material, not releasing and causing the protective film (which is very, very thin) to stretch as I peeled off the tab. So I've ended up with a protective film that's stretched and "ruffled" on the edge in one corner, and doesn't adhere along the edge. I expect it will peel up in time. And besides that, it just doesn't look good. In my package there's a second film, smaller, for use on the top control panel. I thought since I was now aware of the issue with the second tab I could avoid the problem on this one. Nope. I very carefully tried to peel this away and the tab ripped into two pieces this time, leaving about a third of the tab stuck to the protective film. So some fingernail scraping was required, and still there's adhesive bits remaining on this piece in the corner.