Vello LCD Screen Protector Ultra for Canon 60D Cameras

i just purchased 2 of these for canon 1dx mark lll upon installing and removing the outer protective layer the glass has small scratches on it..obviously from manufacturing. tossed it out..installed the second one and same senerio after removing the last outer protection.. the side of the sceen both side's are not adhering properly its not glue i know that, just bad quality control with this product. Now looking for a better alternative. would not recommend, if you do purchase better buy at least 5 and hope one of them is good. GOOD LUCK.

Not too much to say about this - it does its job and is the right size and shape. It all buy disappears when applied, just as you expect from a screen protector these days.

Other reviewers had trouble with aligning this screen protector with the display of their cameras... Im glad to have read their experiences as it helped me to strategize the process. before any unpacking of the protective contents, glove up!! I used basic nitrile gloves and made sure the material was snug against my finger tips for most accurate and slop free operation of my digits. after cleaning the display as instructed, I half pealed the rear protective film from the screen protector and began to align the edges of the protector with the display, adhering one side first. once satisfied with alignment I pressed firmly to keep protector from drifting as I slowly removed the rest of the protective film. allowing the glass protector to make contact with the screen from one side to the other helped minimize and virtually eliminate the air bubbles. Vs trying to make surface contact all at once. after the protector was secured to the display I noticed a slight misalignment, to fix it I shifted the protector with my gloved fingers, pressing down on the screen and in the direction that I needed it to shift. In all I thought it was a simple process, but could see how if you rushed the process could end up with less than satisfactory results. Only wish it came with a protector for the top display by the shutter release. aside from that nit pick, the performance is as expected. Used on a D780.

The screen protector is, well, a screen protector that does exactly what it is intended to do. No problem here. What concerned me - and I did send an email to the packaging department about this - is the the large amount of packaging used (large cardboard box and a lot of plastic bubble materials) for such a small item. The packaging is not even close to being ecologically sound, something I would think would be aware of. John Simpson

I have this same protector on my X-T3 and X-T5. I also purchased the Vello Brand LCD screen protector Ultra on my X-T4 and my Canon 5D Mark IV. The application kit is all very effective and easy to use and the material used for this screen protector is as good as the raw screen. Crystal clear and solid protection. The protector does not extend across the entire glass back but it DOES cover the entire effective lcd display area with room to spare.