Pelican 1557AirWF Hard Carry Case with Foam Insert (Yellow)

This iteration of the yellow Pelican 1557AirWF Hard Carry Case is designed for you to maximize its available space while providing customized protection for your valuable gear. You get the 1557 case with two layers of Pick-N-Pluck foam so you can customize the interior to your specific gear and ensure it is fully protected. Additionally, there is a convoluted eggcrate insert for the inside of the lid and a foam base layer for the bottom of the case to complete the cushioned protection.

Pelican 1557AirNF Hard Carry Case with Liner, No Insert (Yellow)

Built for strength and portability, the yellow Pelican 1557AirNF Hard Carry Case is designed to be dustproof, fully watertight, and crushproof to protect your valuable gear against the harshest handling, shipping, and environmental conditions on the planet. This edition of the 1507Air comes lined, but without foam or other inserts, allowing you the freedom to completely customize the 17.3 x 13 x 9.8" interior to your specific needs and to your specific gear.

Your case is made of a super-light proprietary HPX2 polymer, with honeycomb structural elements, which is up to 40% lighter than most other Pelican polymers and has newly designed dual push-button latches that provide ease-of-use versus previous iterations. Case design features include an O-ring that seals it to an IP67-rating to be dust and waterproof, dual 5/16" (8mm) diameter stainless steel reinforced padlock holes, and a pressure relief valve. This valve regulates the internal pressure, keeping your gear and the case from getting crushed and allowing you to open the case without having to break a tough pressurized seal that may develop. A polycarbonate card holder may be placed on the front or side of the case.

EAN: 019428177164

Pelican 5-Piece Foam Set for 1557Air Case

Designed for their 1557Air case, the Pelican 5-Piece Foam Set can be used to replace the foam that came with your case. It can also be used if you need to put different gear in it than originally intended, or as an option if you bought the case without foam. This set consists of a convoluted egg crate foam lid insert, a base layer for the bottom of the case, and three pieces of customizable Pick N Pluck foam. Pelican recommends that you leave at least an inch of foam between your gear and the inside walls of the case to make sure it is well protected.

EAN: 019428152314