Pelican 1607AirWF Wheeled Carry-On Hard Case with Foam Insert (Yellow)

This iteration of the yellow Pelican 1607AirWF Wheeled Carry-On Hard Case is designed for you to maximize its available space while providing customized protection for your valuable gear. You get the 1607 case with three layers of Pick-N-Pluck foam that allow you to customize the interior to your specific gear with lid and base layers to ensure it is fully protected.

Pelican 1607AirNF Wheeled Hard Case with Liner, No Insert (Yellow)

The waterproof 1607AirNF Wheeled Hard Case in yellow from Pelican is a crushproof hard case made from lightweight HPX2 polymer that will protect and store sensitive gear. The case secures with an updated push-button latching system that uses compressive force to tightly clamp the case shut on three sides. This edition of the 1607Air comes lined but without foam or other inserts, allowing you the freedom to completely customize the roomy 21.1 x 15.8 x 11.6" interior to your specific needs and to your specific gear. Carry your case using one or more of the three overmolded handles or if it s too heavy, extend the pull handle and tow it behind you on its two low-profile, quiet-running wheels.

Your case is made of a super-light proprietary HPX2 polymer with honeycomb structural elements, which is up to 40% lighter than most other Pelican polymers. Case design features include an O-ring that seals it to an IP67-rating to make it dust and waterproof, dual 5/16" (8mm) diameter stainless steel reinforced padlock holes, and a pressure relief valve. This valve regulates the internal pressure, keeping your gear and the case from getting crushed and allowing you to open the case without having to break a tough pressurized seal that may develop. For easy identification, there s a polycarbonate card holder that may be placed on the front or side of the case.

EAN: 019428177324

Pelican 7-Piece Foam Set for 1607Air Case

Designed for their 1607Air case, the Pelican 7-Piece Foam Set can be used to replace the foam that came with your case. It can also be used if you need to put different gear in it than originally intended, or as an option if you bought the case without foam. This set consists of a convoluted egg crate foam lid insert, a base layer for the bottom of the case, and five pieces of customizable Pick N Pluck foam. Pelican recommends that you leave at least an inch of foam between your gear and the inside walls of the case to make sure it is well protected.

EAN: 019428152321