Radial Engineering LX8 Line Level Signal Splitter & Isolator

The single rack space design begins with 100% passive circuit which means it does not require any powering whatsoever to make it work. In this unit, each of the 8 channels is equipped with a premium Eclipse ET-LD4 transformer that is able to handle transients in excess of +26dB at all frequencies right down to 20Hz without audible distortion. This results in an accurate signal transfer with minimal phase shift or artifact. In the studio, the Eclipse transformer delivers added warmth and a natural vintage-sounding compression. When used in larger systems, you benefit from significantly lower noise.

Input connections include a series of front-panel XLRs for easy integration into live racks or a rear-mounted 25-pin D-sub. Output connections include a hardwire throughput, a transformer isolated output, and an auxiliary output, the latter 2 being equipped with ground lift switches to help eliminate hum and buzz caused by ground loops. All rear panel connections are presented with a choice of standard 25-pin D-Sub wired to the Tascam-ProTools standard or with screw-down Phoenix connectors for easy field termination for permanent installations.

All of the 8 incoming signals are routed to the direct output, the transformer isolated output, and an auxiliary out, enabling multiple signal paths to be put into practice without the usual noise that is associated. With all these features, it is suitable for use with most demanding multi-channel audio system.

The Phoenix cable terminal connectors are sold separately

General

8-channel balanced line level-signal splitter & isolator

Handles +26 dB signals without distortion or artifact

Over 100 dB of common mode noise rejection

Eliminates hum and buzz caused by ground loops

Welded 14-guage steel heavy-duty construction for durability

Front Panel

XLR line input (600I©, balanced) wired in parallel with the rear panel D-Sub

ID labels for wax pencil make setup easy

ISO ground lift disconnects the ground on the isolated D-Sub output to help eliminate ground loops

Rear Panel

Isolated output set offers choice of 25-pin D-Sub connector for 8-channel cable harness or Phoenix Euroblock connection for permanent installation

Auxiliary direct output with front panel ground lift switch allows hard-wire passive split for monitors, broadcasts, or PA

Direct output is coupled with the input for direct feed through

Rear panel includes pin-out diagram for the Tascam standard 25-pin D-Sub connector

Balanced input with choice of 25-pin D-Sub, Phoenix Euroblock, or front panel XLR connections