EAN: 676101044993
Guard your electronic equipment, charge your mobile device, and light up your rack with the Radial Engineering Power-2 rackmount surge suppressor and power conditioner. Awarded Best in Show at NAMM 2020, Power-2 offers a sliding multicolor LED tray and nine outlets-one always-on outlet in front and eight switched outlets on the rear-protected against harmful power surges by the USA-made Metal Oxide Varistor.
With steel construction and robust components, Power-2 is ready for the challenges of constant sessions and live gigs. Plus, it yields low system noise while keeping radio-frequency interference out. Occupying just 1 RU of rack space, Power-2 is an ideal addition to gear racks used by studio operators, musicians, engineers, and producers.
LED Illumination
A tray slides out to illuminate rack equipment below, with ultrabright LEDs in seven color options along with a built-in dimmer to adjust as needed.
Unswitched Front-Panel Outlet
The single front-panel outlet will supply power even when the device is switched off, allowing you to easily connect and charge devices without powering on the entire rack.
Switched Rear-Panel Outlets
Eight rear-panel outlets are activated via the backlit power switch. Four of the eight outlets offer ample spacing for wall warts.
USB Charging Port
Also on the front panel is a 5V/1A USB Type-A charging port for mobile devices such as smartphones and tablets.
Fault Protection Indicator
An LED illuminates when the Power-2 s USA-made Metal Oxide Varistor (MOV) is actively working. The MOV is designed to provide continuous protection for your equipment against varying resistance and high-voltage spikes from the AC main power source.
Noise Filtering
Power-2 utilizes shunt-mode technology and is non ground contaminating for lower system noise. A high-rejection RF interference filter is used to keep high frequencies and AM radio signals out of the power line, preventing contamination of audio signals.
Built Tough
A heavy-duty power on/off switch, rugged outlet connectors, and steel construction ensure that the Power-2 performs night after night without fail.
Radial Engineering R800 5005 00 Specs
| Form Factor | Rackmount (with Included Hardware) |
| Type | Conditioner / Surge Suppressor |
| Rated Current | 15 A |
| Number of Circuits | 1 |
| Metering | None |
| Battery Backup | No |
| Integrated Lamps | Yes, 1 x Pull-Out (Front Panel) |
Connections
| Outlets | 1 x NEMA 5-15R (Front Panel, Unswitched, 1 Block-Sized) 8 x NEMA 5-15R (Rear Panel, Switched, 4 Block-Sized) |
| AC Power I/O | 1 x Hardwired Input |
| USB Ports | 1 x USB Type-A |
| Ethernet | None |
| Coaxial | None |
| RJ11 | None |
| Remote | None |
| Lamp Connectors | None |
Electrical
| AC Input Power | 120 VAC, 50 / 60 Hz |
| Load Capacity | Not Specified by Manufacturer |
| Sequencing Delay | None |
| USB Output | 5 V, 1 A |
Protection & Conditioning
| Protection Types & Modes | Overvoltage, Metal-Oxide Varistor (MOV), EMI Filter |
| Circuit Breaker | Yes, at 15 A with Push-Button Reset |
| Undervoltage Protection | None |
| Clamping Voltage | 130 V at 15 A (Line to Neutral) |
| Maximum Spike Current | 20,000 A |
| Surge Energy Rating | 210 Joules |
| Transformer Isolated | No |
| EMI/RFI Noise Filtration | Common-Mode: 10 dB (100 kHz) 41 dB (1 MHz) 50 dB (10 MHz) Traverse/Differential-Mode: 19 dB (100 kHz) 41 dB (1 MHz) 42 dB (10 MHz) |
Environmental
| Certifications | CSA, UL *as per Manufacturer |
| Operating Temperature | 37 to 72°F / 5 to 40°C |
Physical
| Rackmount Size | 1 RU (with Included Hardware) |
| Cable Length | 9` / 2.7 m |
| Wire Gauge | 14 AWG |
| Material of Construction | Steel |
| Cable Management | None |
| Dimensions | 19 x 6.38 x 1.47" / 48.3 x 16.21 x 3.73 cm |
Packaging Info
| Package Weight | 12.42 lb |
| Box Dimensions (LxWxH) | 22.7 x 14.2 x 4.6" |
In the Box
- Radial Engineering Power-2 Surge Suppressor and Power Conditioner
- 2-Year Manufacturer Warranty
No posts found
