Shipping time and rates:
Shipping time and rates:
Sorry, we couldn't find any shipping options for your location. Please contact us, and we'll see what we can do about it.
Yes, we can ship to
United States
Toa Electronics VM-3240VA 240W Voice Alarm System Amplifier (3 RU)
The VM-3240VA from Toa Electronics is a voice alarm system controller with one 240W power amplifier. It can be mounted in a 3 RU EIA-Standard equipment rack. The unit is equipped with analog audio inputs for music distribution, paging announcements, or pre-recorded audio source playback. Its speaker output section has six individual zone selectors with corresponding volume controls. Up to six general messages/tones and four emergency messages/tones may be uploaded to and stored on the VM-3240VA.
Non-emergency messages can be prioritized (seven levels) and triggered by an RM-200M paging microphone or external contact closures. Emergency broadcasts override all non-emergency operations and are triggered from the front panel or a contact closure. All emergency system connections are monitored. The VM-3240VA is fully compliant with NFPA72 requirements and listed to UL2572, ULC-S576 and UL864 for Mass Notification and Fire Voice applications.
The VM-3240VA from Toa Electronics is a voice alarm system controller with one 240W power amplifier. It can be mounted in a 3 RU EIA-Standard equipment rack. The unit is equipped with analog audio inputs for music distribution, paging announcements, or pre-recorded audio source playback. Its speaker output section has six individual zone selectors with corresponding volume controls. Up to six general messages/tones and four emergency messages/tones may be uploaded to and stored on the VM-3240VA.
Non-emergency messages can be prioritized (seven levels) and triggered by an RM-200M paging microphone or external contact closures. Emergency broadcasts override all non-emergency operations and are triggered from the front panel or a contact closure. All emergency system connections are monitored. The VM-3240VA is fully compliant with NFPA72 requirements and listed to UL2572, ULC-S576 and UL864 for Mass Notification and Fire Voice applications.
Toa Electronics VM-3240VA AMQ Specs
| Frequency Response | 50 Hz - 20 kHz, ±3 dB (1/3 rated output) 800 Hz - 2.8 kHz (UL2572) 400 Hz - 4 kHz (CAN/ULC-S576) |
| Distortion | 0.7% or less (at rated output, 1 kHz) |
| S/N Ratio | 85 dB or more |
| Audio Characteristics | Sampling Frequency: 48 kHz A/D D/A Converter: 24 bit |
| Inputs | Input 1 - 3: Combo XLR-1/4" / 6.3 mm jack, -50 dB (Mic) / -10 dB (Line) (changeable), 600 Ohms, electronically balanced Input 4: 14-pin removable terminal block, -50 dB (Mic) / -10 dB (Line) (changeable), 600 Ohms, electronically balanced BGM 1 - 2: RCA pin jack, -10 dB, 10 kOhms, unbalanced External AMP Input: 14-pin removable terminal block, 70 V line |
| Outputs | Speaker Output 1 - 2: Max 240 W per output Speaker Output 3 - 6: Max 100 W per output Speaker Output 1 - 6: 14-pin removable terminal block, total within rated output Recommended Minimum Load: 245 Ohms (20 W) at 70 V for speaker line failure detection Direct Output: 16-pin removable terminal block, direct output from internal or external amplifier Recording Output BGM/Paging: RCA pin jack, 0 dB, 10 kOhms Ground Fault Detection: 0 Ohms Wire to Wire Fault Detection: 0 Ohms |
| VM-Link Connectors | Input: RJ45 female, for VM-3240VA Output: RJ45 female for VM-3240E Link Cable: Category 5 shielded twisted-pair straight cable (Cat5-STP) |
| Link | RM Link Input 1 - 2: Connection to RM-300MF/200M Remote Microphone, RJ45 female connector Maximum Distance: Total 2625` / 800 m between this unit and remote microphones Link Cable: Category 5 shielded twisted-pair straight cable (Cat5-STP) VM Link Output: Audio and control link to a VM-3240E extension amplifier, RJ45 female connector Link Cable: Category 5 shielded twisted-pair straight cable (Cat5-STP) DS Link To Local VX-2000DS: RJ45 female connector Link Cable: Category 5 shielded twisted-pair straight cable (Cat5-STP) |
| Network I/F | 10BASE-T/100BASE-TX (automatic negotiation), RJ45 female connector Maximum Distance: 328` / 100 m between this unit and a switching hub Link Cable: Category 5 shielded twisted-pair straight cable (Cat5-STP) |
| Control | General Control Input 1 - 8: No-voltage make contact input, open voltage: 24 VDC Short-Circuit Current: 14-pin removable terminal block, 2 mA or less Output 1 - 8: Isolated open collector output, withstand voltage: 30 VDC Operating Current: 14-pin removable terminal block, 10 mA or less Emergency Control Input 1 - 5: No-voltage make contact input, open voltage: 24 VDC Short-Circuit Current: RJ45 female connector, 2 mA or less Input 6: Isolated voltage input, inactive: -24 V, ±20% Active: RJ45 female connector, +24 V, ±20% Status Output: Relay contact output, withstand voltage: 40 VDC Operating Current: RJ45 female connector, 2 to 300 mA |
| Power Input/Output | Power Input: From VX-2000DS only (operating range: 20 to 40 VDC) PS Output: 28 VDC / 18 A M4 screw terminal, distance between barriers: 11 mm |
| Power Source | 120 VAC, 60 Hz |
| Power Consumption | 690 VA (at rated output), 260 W (UL60065), 63 W (no signal) |
| Rated Output Power | 240 W, 21 Ohms (UL60065) 200 W, 25 Ohms (UL2572) 200 W, 25 Ohms (CAN/ULC-S576 with separate UPS) 100 W, 50 Ohms (CAN/ULC-S576) Total amplifier output (1 - 6 and Direct Output) |
| DC Output | 22 VDC special application, maximum current 0.3 A (for RM-200M only) |
| Operating temperature | 32 to 120°F / 0 to 49°C |
| Operating Humidity | 5 to 95% RH (no condensation) |
| Finish | Panel: Aluminum, hair-line, black Case: Surface-treated steel plate, black paint |
| Dimensions | 18.98 x 5.22 x 16.98" / 48.2 x 13.3 x 43.1 cm |
| Weight | 36.38 lb / 16.5 kg |
In the Box
- Toa Electronics VM-3240VA 240W Voice Alarm System Amplifier (3 RU)
- 6.6` Power Cable
- 2 x 9.8` Link Cable
- 4 x Plastic Feet and Screws
- Emergency Microphone
- 3 x 14-Pin Removable Terminal Plugs
- 16-Pin Removable Terminal Plug
- 5-Year Manufacturer Warranty
No posts found
