The Yorkville CA1 is a Coliseum Series installation amplifier offering six input channels, four output zones, and straightforward controls for versatility and ease of use in restaurants and retail environments as well as houses of worship, offices, and conference rooms. With 180W of output power, it can drive a 4-ohm speaker load or four 70V speaker systems while a dedicated preamp out can feed a subwoofer or an audio recorder.
Its wide range of inputs include a front-panel 1/4" mic input with voice priority, three XLR-1/4" combo mic/line inputs with selectable 24V phantom power for podium/lavalier condenser microphones, two stereo RCA inputs with 4-stage sensitivity selection, and a dedicated 600-ohm telephone input. In addition to having screw terminals to accommodate hookup of constant-impedance or constant-voltage speakers, the CA1 provides a 1W / 8-ohm auxiliary loudspeaker output and a front-panel 1/4" monitor output.
Thanks to individual channel volume knobs, a large master volume control, and 2-band EQ, the CA1 allows efficient mixing without having to enter menus or even leave the front panel. Per-zone and all-zone speaker selection switches enable simple management of all output zones. The CA1 s sturdy steel chassis can be mounted in 3 RU of rack space in a standard 19" equipment rack.
180W (mono) for driving a 4-ohm speaker load or four separate 70V speaker systems (one system per zone)
Front-panel 1/4" TS mic input with voice priority
Three XLR-1/4" TRS combination mic/line combination inputs with selectable 24V phantom power
Two stereo RCA inputs with 4-stage input sensitivity selection for sources such as CD players, cassette decks, satellite tuners, and DVD/video systems
Master volume, 2-band EQ, and per-channel volume controls
Speaker connect/disconnect switches for each zone and all zones
RCA preamp output can be used to feed an auxiliary power amplifier or active subwoofer to enhance the system, or to feed video or audio recording equipment
600-ohm telephone paging input
Front-panel 1/4" monitor output and 1W / 8-ohm rear-panel speaker output for monitoring music signals
Outputs for speakers with constant impedance (4-ohm speakers) and constant voltage (25, 70, or 100 volts)
LED VU meter
Protection against short-circuiting between output terminals
Direct current supplies 24 VDC
Sturdy rack-mountable 3 RU steel chassis
EAN: 840402011187
Yorkville Sound CA1 Specs
| Number of Channels | 6 |
| Power Rating | 4 Ohms / 70 V: 180 W |
Performance
| Protections | AC Fuse, Output Limiter, Short Circuit |
| Frequency Response | 50 Hz to 15 kHz ±3 dB |
| Input Sensitivity | 1/4" Mic: 2 mV / -54 dB (Unbalanced) Combo XLR-1/4" Mic: 1 mV / -60 dB (Balanced) Combo XLR-1/4" Line: 75 mV / -22 dB (Balanced) Stereo RCA Aux: 100 mV to 1 V / -20 dB to 0 dB (Unbalanced) RCA Line: 1 V / 0 dB (Unbalanced) |
| Input Impedance | 1/4" TS Mic: 300 Ohms (Unbalanced) XLR Mic: 600 Ohms (Balanced) 1/4" TRS Line: 47 Kilohms (Balanced) Screw Terminal Telephone/PBX: 600 Ohms (Unbalanced) RCA Line: 10 Kilohms (Unbalanced) 2RCA Aux: 240 Kilohms (Unbalanced) |
| SNR | > 55 dB |
| THD | < 1% (1 kHz, at Rated Power) |
Signal Processing
| Audio Delay | None |
| EQ | 2-Band |
| Ducking/Muting | Yes |
| Limiting | Clip |
Connectivity
| Analog Audio I/O | 1 x 1/4" TS Female Unbalanced Mic Input 3 x Combo XLR-1/4" TRS Female Balanced/Unbalanced Line/Mic Input 2 x 2RCA TS Female Unbalanced Aux Input 1 x Screw Terminal 3-Pin Unbalanced Tel/PBX Input 1 x RCA TS Female Unbalanced Line Input 1 x RCA TS Female Unbalanced Line Output 1 x Screw Terminal 5-Pin Unbalanced Speaker Output 7 x Screw Terminal 1-Pin Unbalanced Speaker Output 1 x Screw Terminal 2-Pin Unbalanced Speaker Output 1 x 1/4" TRS Female Unbalanced Monitor Output |
| Digital I/O | None |
| USB | None |
| Phantom Power | 24 VDC |
Power
| AC Input Power | 115 to 230 VAC, 50 / 60 Hz |
| AC Power Connector | 1 x IEC / NEMA 5-15 |
Physical
| Display & Indicators | Front Panel: 1 x Green LED (Power) 1 x Red LED (Clip/Limit) 1 x Multi-Segment LED Meter (Output) |
| Rackmount Size | 3 RU (with Included Hardware) |
| Cooling | Convection |
| Dimensions | 18.9 x 5.9 x 12.6" / 48.0 x 15.0 x 32.0 cm |
| Weight | 19.8 lb / 9 kg |
Packaging Info
| Package Weight | 29.3 lb |
| Box Dimensions (LxWxH) | 21.8 x 16.9 x 9.1" |
In the Box
- Yorkville Sound CA1 Coliseum Series 70V Installation Amplifier
- Power Cable
- 2-Year Manufacturer Warranty
Customer reviews
Recommendation for purchase
