The M2T IEM Digital Half-Rack Transmitter with Dante from Lectrosonics features transmission power up to 50 mW for extended operating range and locking XLR/TRS combo connectors, that facilitate up to four channels of analog audio sources. The Dante connection is equipped with two RJ45 connectors, four audio RX channels, and is internally routable. With ultra-low latency, 24-bit audio, and two stereo-digital channels, the M2T is an IEM transmitter for professional broadcast applications.
Built with a USB port for firmware updates and an IR port for fast setups, the M2T transmitter has a large, high-resolution backlit color LCD with large membrane switches for an intuitive interface visible in daylight or dimly-lit conditions. Analog signals are converted to an internal 24-bit digital format that is encoded, organized into packets, and passed to an RF modulator. The RF signal is filtered before and after amplification to suppress out-of-band noise and spurious signals.
Additionally, the M2T transmitter employs a technology that provides a frequency response from 20 Hz to 15 kHz with maximum channel separation. This digital audio technology eliminates a compandor and the associated artifacts, resulting in crystal clear sound, rock-solid stereo imaging, and low distortion.
Lectrosonics M2T-DANTE Specs
| RF Power Output | 2 x RF carriers, 2 audio channels each 10, 25, or 50 mW; adjustable |
| Antenna Output | 2 x BNC sockets |
| Operating Frequencies | 470 to 608 MHz |
| Frequency Selection Steps | 25 kHz |
| Frequency Stability | ± 0.002% |
| Modulation | 8 PSK |
| Emission Designator | 200KG7E |
| Spurious Radiation | Compliant with ETSI EN 300 422-1 |
| Equivalent Input Noise | -128 dBV |
| Audio Frequency Response | 20 Hz to 15 kHz |
| Audio Input | -10 dBV or +4 dBu settings with ±5 dB trim |
| Audio Input Jack | 4 x combo XLR/TRS connectors |
| Dante Connection | 2 x RJ45, 4 audio channels |
| Ethernet Connector | RJ45 |
| USB | Micro USB on front panel for firmware updates |
| IRDA | IR transceiver for sync of receivers |
| Input Impedance | Line: 2 kOhms |
| Headphone Jack | 1/8" / 3.5 mm stereo |
| Power Requirements | 9 to 18 VDC |
| Power Consumption | 5 W |
| Dimensions | 1.8 x 8.4 x 7.8" / 4.4 x 21.3 x 19.7 cm |
| Weight | Not specified by manufacturer |
In the Box
- Lectrosonics M2T IEM Digital Half-Rack Transmitter with Dante (470 to 608 MHz)
- 2 Years Manufacturer Warranty
No posts found
