The matte gray Schoeps Colette CMC 1 Microphone Amp and MK 4 Cardioid Condenser Capsule is a space-saving Colette Series modular cardioid condenser microphone bundle designed to provide frequency-independent directionality and transparent, low-distortion sound pickup of dialog, foley, and instruments in film, television, and music production.
It includes the CMC 1 miniature microphone amplifier, the MK 4 condenser capsule, a foam windscreen, a stand clamp, and a premium case. Thanks to the inclusion of the ultracompact CMC 1, this bundle serves as a lighter and smaller alternative to the CMC 6 without compromising sonic performance.
Schoeps CMC 1 U Miniature Colette Microphone Amplifier (Matte Gray)
The matte gray Schoeps CMC 1 U is a miniature Colette Series microphone amplifier offering uncompromising high fidelity in a lightweight and ultracompact form factor for studio recording, broadcast, and live stage applications. Presented as an alternative to the renowned Schoeps CMC 6 amplifier, the CMC 1 U is compatible with all existing MK mic capsules and Colette active accessories (all available separately).
It features a balanced XLR output, compliance with 12 or 48V phantom power, and low current consumption. Its Schoeps RFI Shield provides high immunity from RF interference for a clean, low-noise signal. The CMC 1 U supports the high maximum SPLs tolerated by the various MK mic capsules (available separately).
- Complete alternative to the renowned CMC 6 amplifier
- Can be used in place of the CMC 6 with no compromise
- XLR output connector
- Electrical characteristics of the CMC 1 U are equal to, or even better than, those of the CMC 6
- 1.4" long (about a third the size of the CMC 6)
- 1.3 ounces (about 40% lighter than the CMC 6)
- Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
- Very high immunity from RF interference with the Schoeps RFI Shield
- Includes mic clip for easy attachment to a mic stand
- Suspension mounts such as the Rycote INV-6 are available separately
Schoeps MK4 Cardioid Capsule for CMC Preamplifiers
The Schoeps MK4 is part of the Colette series of modular capsules designed for use with the CMC preamplifiers. The cardioid polar pattern results in maximum rejection of rear incidental audio signal, eliminating off-axis noise and feedback. The cardioid pattern allows microphone placement to occur farther from the sound source than a pressure transducer of equivalent sensitivity. The MK4 is ideal for both speech and music capturing, resulting in rich detail without coloration. The MK4 is also a viable solution for X/Y or Mid-Side stereo recording.
Cardioid Polar Pattern
The cardioid pattern effectively rejects rear and off-axis audio signal resulting in greater signal to noise ratio and feedback rejection.
Excellent Directional Response
The cardioid characteristic allows the MK4 to be placed at further proximities from the signal source without degradation.
Wide Linear Frequency Response
The wide frequency response ensures accurate detail regardless of the source signal.
Schoeps Solid Foam Teardrop Popscreen for Schoeps Colette Series Microphones (Gray)
This gray Solid Foam Teardrop Popscreen from Schoeps is an acoustic foam close-speech popscreen intended for use with Schoeps Colette Series microphones, but compatible with other microphone capsules as well. It provides sufficient protection at normal speaking distances for cardioids and other directional capsules, especially when speech capsules are used. With omnidirectional capsules, it may even be used outdoors in light wind. This popscreen has minimal effect on sound quality.
For moderate distances from the person speaking
Can also be used as a windscreen for pressure transducers
Negligible effect on sound quality
Schoeps CMC 1 U Miniature Colette Microphone Amplifier (Matte Gray) Specs
Frequency Range | 20 Hz to 20 kHz |
Maximum Output Voltage | 1.8 V / 5 dBV with 1-Kilohm Load |
Maximum SPL for 0.5% THD | P48 with MK 4 Capsule: 135 dB SPL P12 with MK 4 Capsule: 131 dB SPL |
Impedance | 50 Ohms (±1 Ohm, 8 Hz to 50 kHz) |
Minimum Load Impedance | 1 Kilohm |
Sensitivity | Capsule-Dependent Sensitivity |
Low-Cut Filter | 12 dB/Octave at 20 Hz |
Common Mode Rejection Ratio | >55 dB at 1 kHz |
Maximum Cable Length | Up to 1312` / 400 m |
Output Connector | 1 x 3-Pin XLR Male |
Operating Current Consumption | P48: 2 mA P12: 3 mA |
Operating Voltage | P48: 30 to 52 VDC P12: 11 to 13 VDC |
Length | 1.4" / 36 mm |
Diameter | 0.8" / 20 mm |
Weight | 1.3 oz / 36 g |
Packaging Info
Package Weight | 0.72 lb |
Box Dimensions (LxWxH) | 7.4 x 4.3 x 1.3" |
Schoeps MK4 Cardioid Capsule for CMC Preamplifiers Specs
Transducer | Condenser |
Polar Pattern | Cardioid (MK4) |
Frequency Response | 40Hz to 20KHz (MK4) |
Dynamic Range (Typical) | not specified by manufacturer |
Signal-to-Noise Ratio | 79 dB-A (MK4) |
Maximum Input Sound Level | 132dB (MK4) |
Power Requirements | 12V - 48V Phantom Power (CMC6) |
Output Impedance | Minimum Load: 600 Ohms (CMC6) (If a lower load impedance is used, the main effect will be to reduce the maximum output level of the microphone.) |
Output Connectors | 3-pin XLR (CMC6) |
Pad | No |
Low Frequency Roll-Off | No |
Dimensions | 4.57 x .78" (116 x 20mm) (Length x Diameter) (with CMC6) |
Weight | 68g (with CMC6) |
Packaging Info
Package Weight | 0.12 lb |
Box Dimensions (LxWxH) | 8 x 5 x 1" |
Schoeps Solid Foam Teardrop Popscreen for Schoeps Colette Series Microphones (Gray) Specs
Maximum Noise Attenuation | 20 dBA in 11 mph / 18 km/h Wind |
Material | Foam |
Outer Diameter | 1.77" / 45 mm |
Length | 2.75" / 70 mm |
Packaging Info
Package Weight | 0.02 lb |
Box Dimensions (LxWxH) | 6.4 x 3.05 x 1.9" |
In the Box
- Schoeps SG20 Microphone Stand Clamp
- 2-Year Manufacturer Warranty
- 2-Year Manufacturer Warranty
No posts found