Lectrosonics SSM Micro Belt-Pack Wireless Transmitter with VT500 Lavalier Mic Kit (A1: (470.100 - 537.575 MHz))

The SSM Micro Belt-Pack Wireless Transmitter with VT500 Lavalier Mic Kit from Lectrosonics features a miniature SSM transmitter and a Voice Technologies VT500 Omnidirectional microphone with a 3-pin LEMO connector. It can be used when paired with a Lectrosonics receiver (sold separately) for applications such as live stage, theater, broadcast TV, and more or anywhere else where concealment in costuming is required.

The SSM s servo bias input accepts mic or line level signals with a wide range of gain adjustments in 1 dB steps. LEDs on the keypad allow precise gain adjustments and provides maximum signal to noise ratio with minimum distortion.

The VT500 Omnidirectional microphone has a flat, wide frequency response that is designed for crucial reproduction of vocals. Designed for outstanding performance in broadcast, theatrical and sound-reinforcement applications, the VT500 s frequency response delivers exceptionally transparent audio reproduction with minimal noise. The accessories included with the kit are the following: An Alligator Clip, a Dracula Mount, a Standard Windscreen, a Tie Tac Clip, a Belt Clip, a 3.7V Lithium-Ion Battery Pack, and a Battery Charger.

Lectrosonics SSM Digital Hybrid Wireless Miniature Transmitter (A1: 470.100 to 537.575 MHz)

The SSM from Lectrosonics is a miniature Digital Hybrid Wireless Transmitter with selectable frequencies across a maximum tuning range of 76.7 MHz and has selectable 25 or 50 mW RF output power. It can be used in applications where concealment in costuming is required or any other production such as for live stage, theater, houses of worship, reality TV, and more.

The SSM features selectable frequencies in 100 kHz or 25 kHz steps yielding a total of 3,072 available frequencies across three standard frequency blocks. Its lithium-ion battery provides power and sits in a stainless-steel battery door that latches closed and cannot be jarred open accidentally.

The servo bias input that is built into the transmitter accepts mic or line level signals and uses gain adjustments in 1 dB steps. The LED indicators on the membrane keypad allow you to monitor precise gain adjustments and settings. A built-in limiter in the preamp, handles signal peaks over 30 dB. This provides you with the maximum signal to noise ratio and minimum distortion for input, but still provides protection against input overloads.

The SSM is compatible with earlier analog Lectrosonics receivers IFB, and some other receivers, from manufacturers that utilize the DSP emulation mode, which is selectable in the LCD menu. The SSM transmitter housing is constructed of machined aluminum and has a hard, black electroless nickel finish called ebENi.

The SSM transmitter tunes across a range of over 76 MHz. This tuning range covers three standard Lectrosonics frequency blocks

The transmitter operates from a 3.7V rechargeable battery that will provide about four hours of operation per charge

The factory-supplied battery charger provides a folding NEMA 2-prong plug, and will operate from 100-240 VAC sources. The LED glows red during charging and turns green when the battery is fully charged

The LCD is a numeric-type Liquid Crystal Display with screens for adjusting output power, frequency, audio level, low frequency audio roll-off, and various modes and options

The antenna is a flexible whip made of galvanized steel, permanently attached to the transmitter to prevent damage from heavy use. The IR port is capped with a translucent dome material to broaden the reception angle. The input jack is a rugged 3-pin LEMO connector with a threaded locking sleeve

An infrared sync port on the SSM allows for quick setup with compatible receiver systems. A micro-B USB port makes it possible for firmware updates in the field as advanced features are added in the future

The SSM responds to remote commands for frequency, audio level, sleep modes, and other settings from the RM remote unit or 3rd party smartphone apps

Voice Technologies VT500 Omnidirectional Lavalier Condenser Microphone (Black, LEMO 3-Pin Connector)

The black Voice Technologies VT500 (LEMO 3-Pin Connector) is a durable omnidirectional lavalier condenser microphone optimized for speech reproduction in theater, broadcast, television, and video production. The omnidirectional polar pattern picks up sound from all directions and its 40 Hz to 20 kHz frequency response has a slight high-frequency boost to enhance vocal clarity.

The injection-molded body is shockproof and protected from RF interference. The flexible 5 cable provides isolation from noise caused by material rubbing against it. The included windscreen reduces wind noise and the supplied clips enable versatile mounting configurations. The VT500 includes a waterproof carrying case.

Connector

LEMO 3-pin connector for Sennheiser SK series transmitters

Compatibility

Works with Sennheiser SK Series, 2000 Series, Lectrosonics SSM, Audio Ltd. miniTX (En2), Audio Ltd. miniTX (2040), and Audio Ltd. 1010 Digital body-pack transmitters

Flexible Mounting Options

A variety of mounting clips are included for versatility in attachment methods

Wide Flat Frequency Response

The lavalier features a wide, flat frequency response for transparent signal reproduction

Omnidirectional Polar Pattern

The omnidirectional pattern provides pick up from all around the microphone s capsule

RF Suppression Filter

Radio-frequency noise is suppressed via an internal RF filter