intellijel Stomp Effects Pedal Send/Return with Expression Control and LFO Eurorack Module (8 HP)

intellijel STOMP-3U Overview

Expand your palette of possibilities by adding stomp boxes to your modular setup with the intellijel Stomp, a Eurorack module with an effects pedal send/return, expression control, and a built-in LFO. Stomp enables the modular synthesist to interact with the impressive assortment of delays, choruses, flangers, phasers, fuzz boxes, tremolos, wah-wahs, amp simulators, compressors, and pitch shifter pedals available to guitarists. Stomp supports your pedal's expression pedal input if it has one, and features a built-in LFO to modulate your expression pedal's input.

Conversely, guitarists can plug their guitar directly into Stomp's RETURN jack, giving them access to the myriad filters, ring mods, wavefolders and most importantly the near-infinite CV modulation delights inherent in Eurorack. The module includes a power ribbon cable.

At a Glance

• Robust Neutrik 1/4³ TS connectors for the SEND/RETURN and TRS for the Expression interface
• Signals arriving at Stomp's RETURN jack pass through a Class-A triode emulator, allowing for some tubelike overdrive at high-gain settings.
• SEND output is normalled to RETURN input, so even without 1/4³ cables you can route Eurorack signals through the FET stage for coloring.
• Stomp is more than just a simple level shifter it's also an impedance converter, which provides proper drive and loading for any FX pedals or instruments you connect.
• Separate gain controls on both the SEND and RETURN. This enables you to adjust the level of any audio being sent to the FX pedals as well as any audio coming back into the modular. Not only does this allow you to optimize the signal-to-noise ratio, but by significantly boosting the RETURN level, you can achieve some pleasingly overdriven tones.
• Supports both PEDAL/INST and LINE levels via a front-panel switch.
• Use Stomp's RETURN circuit as a direct box for connecting any instrument.
• The high-input impedance of the RETURN circuit allows it to be used as a piezo pickup preamp for acoustic instruments.
• Use Stomp in the studio as an active reamping device to play prerecorded tracks back through guitar amplifiers or pedals.
• All inputs are protected for minimum RF interference.
• Return signal can be phase inverted for use with those pedals or effects types that invert phase.
• Low SEND output impedance for driving long cables, lower noise, and minimum interference from outside sources.
• The Expression Pedal Output converts analog CV sources (or the internal LFO) into an output compatible with most stompbox Expression inputs.
• If the internal LFO is set to 0 Hz (full CCW), the EXPR knob can be used as a manual expression pedal control level.

Eurorack Ready

• 8 HP Eurorack format module
• Maximum depth: 1.4" (35mm)
• Includes power ribbon cable with Eurorack power headers
• Power consumption: +12V: 47mA, -12V: 13mA