ART RP-1 Preamp for Dynamic& Ribbon Microphones
EAN: 840402047421
The ART RP-1 is a preamp that relies on phantom power and is meant for use with a dynamic or ribbon microphone. It is designed to increase the performance of the microphone, allowing you to get a cleaner, more nuanced tone across long cable runs or when routing your mic into your recording interface.
EAN: 840402047421
The ART RP-1 is a preamp that relies on phantom power and is meant for use with a dynamic or ribbon microphone. It is designed to increase the performance of the microphone, allowing you to get a cleaner, more nuanced tone across long cable runs or when routing your mic into your recording interface.
The preamp accommodates one microphone via XLR connection. A variable impedance control lets you customize the performance of each of your dynamic or ribbon mics with the preamp, doing so to ensure the best tonal performance. A low-cut filter set to 100 Hz lets you take bass-heavy rumble and noise out of the signal.
The preamp runs on phantom power from mixers and interfaces, so as a bonus, you will not harm your ribbon mics with phantom power if the RP-1 sits between your mic and its eventual destination.
ART RP-1 Specs
| Number of Channels | 1 |
| Connections | 1 x XLR Input 1 x XLR Output |
| Input Impedance | 150 Ohms to 10 Kilohms, Variable |
| Maximum Input Level | -18 dBu |
| Maximum Output Level | +1 dBm at 600-Ohm Load, +10 dBu at 10-Kilohm Load |
| Low-Pass Filter | Switchable, 100 Hz, Single Pole |
| Gain | 20 dB at 600-Ohm Load, +28 dB at 10-Kilohm Load |
| THD | 0.002% at 1 kHz, Typical |
| EIN | -129 dBu, C-Weighted |
| CMRR | >40 dB, 20 Hz to 20 kHz |
| Power Requirements | Standard 48V Phantom Power Supply, 8 mA |
| Dimensions | 1.3 x 1.1 x 5.2" / 3.2 x 2.8 x 13.2 cm |
Packaging Info
| Package Weight | 0.38 lb |
| Box Dimensions (LxWxH) | 6.6 x 2.5 x 2.1" |
In the Box
- ART RP-1 Preamp for Dynamic & Ribbon Microphones
- 3-Year Manufacturer Warranty
No posts found
