Adam Professional Audio T7V T-Series Active Nearfield Monitors with 130W Subwoofer Studio Kit

Adam Professional Audio T7V T-Series Active Nearfield Monitor (Single)

The single, Adam Professional Audio T-Series T7V is an affordable, high-quality, near-field, active studio monitor well suited for project studios, commercial recording facilities, and broadcast environments. The speaker features Adam s U-Art 1.9 accelerated ribbon tweeter with HPS waveguide and a 7 polypropylene woofer with a rear-firing bass-reflex port. The unit is bi-amped with 50W allocated to the woofer, while 20W powers the tweeter, which combine to provide a frequency response of 39 Hz to 25 kHz and a maximum SPL of 110 dB. The rear panel offers XLR and RCA connections with controls for input sensitivity, gain, high-shelf (-2, 0, +2 dB), and low-shelf (-2, 0, +2 dB). The Adam Professional Audio T7V ships with a power cord.

U-ART 1.9 Accelerated Ribbon Tweeter

• Allows longer operation with fewer signs of fatigue
• Breakup is prevented by the folded diaphragms, distortions are effectively reduced to a minimum
• Advanced dynamic range due to acoustically effective diaphragm surface that is 2.5 times bigger (compared to a classic tweeter according to the piston principle)

Air velocity ratio of 4:1 during the sound generation by folded U-ART membrane

• Direct, fast response in the high-range even with complex transients

HPS waveguide from the S Series

• Makes dispersion more consistent and imaging more stable over a wider area
• Reduction of early reflections on the surfaces of mixing consoles, desks, and more

Lightweight polypropylene construction of the woofer

• Excellent transient response even at high sound levels without breakup of the diaphragm

Vertical 2-way system with 7 woofer

• High resolution of the stereo image

Rear-firing bass reflex port

• Bass reproduction with very low compression

Linear frequency response of 39 Hz to 25 kHz

• Unbiased reproduction in a wide frequency band

Maximum peak sound pressure per pair in 3.3 (1 m) 110 dB

• Powerful, compression-free sound reproduction even at very high sound levels

DSP-powered crossover design

• Smooth frequency response without interference between the drivers in the critical midrange

Simple room acoustic adjustments via high- and low-shelf filters

• Allows optimal adaptation to acoustically difficult listening environments or individual preferences

Analog inputs over XLR and RCA

• Optimized for balanced and unbalanced line signals

Acoustically optimized cabinet geometry

• Reduction of unwanted reflections on the cabinets

Adam Professional Audio T10S - 130W 10 Active Subwoofer

The Adam Audio T10S is a compact, active subwoofer designed to extend the bass response of any nearfield studio monitor. However, the subwoofer s performance, features, and connectivity are specifically engineered to complement Adam Audio s T5V and T7V full-range studio monitors. The small footprint of the enclosure allows it to be easily integrated into any studio environment.

A 130W amplifier powers the 10 down-firing paper cone woofer, which provides a frequency range of 28 to 120 Hz with a maximum SPL of 104 dB. The two-channel crossover is adjustable, allowing for calibration of the bass signal for optimal performance of the entire system. The rear-panel controls include a level knob, a 0/180° phase switch, and three crossover selections including bypass, 80, and 120 Hz. Additionally, there is a remote switch subwoofer bypass (1/4 ) input, which allows you to activate/deactivate the subwoofer with an optional TS footswitch. The Adam Audio T10S ships with a power cord.

• Linear bass reproduction down to 28 Hz
• Ideal for smaller nearfield monitors, specifically the T-Series
• >=104 dB maximum peak sound pressure
• Powerful, compression-free sound reproduction even at very high sound levels
• High-efficiency PWM 130W amplifier
• Low-distortion amplification at both low and high volume levels
• 10 woofer with paper diaphragm
• Unrestricted bass reproduction for low-fatigue operation
• Easy manual or automatic (de-)activation (via optional footswitch)
• Crossover optimized for T Series T5V and T7V studio monitors
• Analog XLR / RCA inputs and outputs
• Optimized for balanced and unbalanced line signals (+4 or -10 dBu)
• Small footprint for flexible positioning in the room for optimal sound results