Axler Hammerhead Follow Focus

While follow focus systems are classically employed when a crew is available, the Hammerhead can also be used by solo operators. The marking disk is angled to be visible from both the side and the rear, for a clear line-of-sight from the operator and assistant positions. Assistants can use the ARRI standard accessory port for whips or speed-cranks.

Smooth Focus Adjustment

Boasting a large hand wheel, focus adjustments with the Hammerhead can be smooth and precise. Use the included Allen wrench to adjust the gearbox stiffness to your preference.

Adjustable Hard Stops

Easily repeat focus moves by setting the end stops of the focus move on the hand wheel itself. Flip up the marking index to release the stops so you can reset them for your next shot.

Accommodates Multiple Lens Diameters

Release the bottom thumbscrew while the Hammerhead is locked down on the rods to slide the hand wheel and gearbox to mesh with your lens. The sliding range can accommodate lenses ranging in 20-100mm in diameter.

Switchable Drive Gear

With shorter lenses, connecting the follow focus can be difficult if the lens gear is fixed. The Hammerhead features a side-switchable drive gear, meaning the drive gear can be mounted on the side closer to the camera for working with short lenses commonly found on mirrorless cameras.

Accessory Port

At the center of the hand wheel is an ARRI standard accessory port for whips, cranks, and other accessories, either for the operator or an assistant camera operator.