ProAm USA Orion DVC200 12' Camera Crane

ProAm USA Orion DVC200 8` Camera Crane/Jib

EAN:728028003970

Capture smooth, dynamic sweeping pans and camera rises with the Orion DVC200 8` Camera Crane/Jib from ProAm USA. Supporting loads up to 8 lb, the 8` arm adds 5` of reach from the fulcrum point, with an optional 4` extension available for additional length. It is constructed from 1` and 2` aluminum tubing, setting up quickly and without tools to benefit on-location productions. At the end of your shoot, the jib breaks down into two 4` long sections for easier travel and storage. To balance your load, a 1` counterweight bar at the rear of the arm accepts standard and readily available dumbbell weights.

Features

• 8` arm jib arm
• Supports loads up to 8 lb
• Adds 5` of reach from fulcrum
• Optional 4` extension bar for increased length
• Constructed from 6061 aluminum with powder-coated finish
• Stainless steel bearings for smooth motion
• Quick, tool-less setup
• Breaks down into two 4` sections for storage and travel
• Camera can auto-tilt to remain level, or use can remove a pin to manually tilt the camera
• 1` counterweight bar to hold standard dumbbell weights
• 1/4`-20 and 3/8`-16 tripod mounting thread

ProAm USA 4` Extension for DVC200 and DVC210 Camera Cranes

EAN:728028003994

The 4` Extension from ProAm USA allows the 8` DVC200 and DVC210 Camera Cranes to be extended to 12`.

This extension is only compatible with DVC200 models that were purchased AFTER March 12, 2007. While it allows the 8` model to have a 12` reach, it is NOT intended to bring the DVC250 to 16`.