DigitalFoto Solution Limited TPII-SE Vest, Arm, and Sled Support System for Camera and Gimbal

DigitalFoto Solution Limited TPII-SE Overview

Reduce bounce and shake in your shots while distributing weight from your arms to your waist and back when using a Moza Air 2, DJI Ronin-S, DJI Ronin-SC, DJI RS 2, RS 3, RS 3 Pro, Zhiyun CRANE 3/3S/2S, or any single-handle gimbal with a 3/8" -16 or 1/4" -20 mounting thread using the TPII-SE Vest, Arm, and Sled Support System from DigitalFoto. The support vest is fully adjustable to fit a wide range of body sizes. Combined with the included arm and sled, the vest system supports gimbal rigs that weigh up to 23 lb.

The dual-spring arm mounts on the front of the vest and features two adjustable joints for smooth movement in multiple directions. The sled installs onto the extension arm, and the gimbal installs onto the sled using the included quick release Manfrotto-type plate. A counterweight kit for installation on the sled base is included to offset heavier rigs. A V-mount battery plate and multiple power cables and adapters are included for facilitating camera power.

Also included is a soft carry case to store and transport the kit.

Compatibility

Compatible with but not limited to the following gimbals:

• Moza Air 2
• DJI Ronin-S, Ronin-SC
• Zhiyun CRANE 3, CRANE 3S, CRANE 2S
• Single-handle gimbals with 3/8" -16 or 1/4" -20 mounting thread

Compatible with but not limited to the following cameras:

• Sony a7, a7R, a7 II, a7S II, a7R II, a6500, a6300, a5100, a5000, a3000, NEX5, NEX7, DSC-RX10
• Canon EOS 5D Mark II, 5D Mark III, 5D Mark IV, 6D, 60D, 7D, 7D Mark II, 70D, 80D, 5DSR
• Blackmagic Pocket Cinema Camera 6K, 6K Pro, 4K

Features

• Adjustable vest fits most body sizes
• 23 lb load capacity
• Reduces up-and-down motion bounce and shake
• Adjustable dual-spring arm with two joints
• Gimbal sled with counterweights and Manfrotto-type quick release plate
• V-mount battery plate
• Multiple camera power cables

EAN: 725576434935