Kessler Crane MG1086 KillShock ATP All-Terrain Plate Isolator System

Kessler Crane MG1084 KillShock ATP (All-Terrain Plate)

The Kessler Crane MG1084 KillShock ATP (All-Terrain Plate) is a cheese plate that has been specifically designed to work with all RadPower Bikes front and rear racks to mount cameras, gimbals, pan tilt heads, and virtually any camera or camera rig. The KillShock ATP features redundant mounting holes for M?VI Toad In The Hole, Ronin 2 and Ronin S Universal Mounts, Kessler Kwik Release Receiver, and Kessler HD Angle Plate, as well as 1/4 -20 and 3/8 -16 tapped and pass-through holes that provide multiple mounting possibilities.

The plate can be rotated 180 degrees to have multiple mounting positions, and it features markings for many of the mounting holes that identify specific accessory mounting locations. Although specifically designed for use on RadPower Bikes, the combination of pass-through and threaded mounting holes enable these versatile cheese plates to be mounted on other platforms as well.

Extremely versatile mounting plate can support hundreds of pounds without bending or deforming

It features 120 total threaded and pass-through mounting holes that allow you to mount the All-Terrain Plate onto different platforms while allowing you multiple mounting points for rigs and accessories

Large holes are machined into the plate to reduce weight and provide tether anchor points

Kessler Crane KillShock Medium-Duty Shock Module (Red)

Use the red KillShock Medium-Duty Shock Module from Kessler to adjust the tension of the KillShock Isolator System to a medium-duty level. Each Shock Module consists of three cables that provide a certain level of tension to remove vibration from your rig. The color denotes the level of tension-blue denotes a light level, red denotes medium, and black denotes heavy. The light module is best-suited for DSLR or smaller cine cameras. The heavier and bulkier the rig, the more tension required.

The KillShock Isolator System utilizes up to eight Shock Modules to remove vibration from any shot whether on a crane, jib, dolly, or vehicle, and they can be used in any combination of 8, 6, 4, or 3 modules or combined in any configuration of tension levels for balance and fine-tuning.

Used with the KillShock Isolator System to remove vibration from moving shots

Medium-Duty Shock Module consists of three red tension cables

Light-Duty modules are best-suited for DSLR or smaller cine cameras Medium- and Heavy-Duty modules are used with heavier rigs

Configure with 8, 6, 4, or 3 modules and varied module types (Light-, Medium-, or Heavy-Duty) to create different levels of shock isolation