DigitalFoto Solution Limited TRINIPOD Carbon Fiber Monopod Sled and Yoke Collar System

DigitalFoto Solution Limited TRINIPOD Carbon Fiber Monopod Sled and Yoke Collar System

EAN: 747045876121

The DigitalFoto TRINIPOD Carbon Fiber Monopod Sled and Yoke Collar System enables mounting gimbals such as the DJI RS 2, RSC 2, or Ronin-S, as well as the Zhiyun-Tech Crane 3S, to virtually any vest/arm stabilizer system with a 16mm pin, thus turning your single-hand gimbal into a full vest and arm stabilizer system that combines your electronic gimbal with a mechanical gimbal. This allows you to gain the advantages of a vest arm support system-such as less arm fatigue-and increased payload as the TRINIPOD supports cameras and rigs weighing up to nearly 40 lb.

You can mount gimbals with either a 1/4 -20 or 3/8 -16 mounting hole on the adjustable height riser, which has an adjustment range from 18 to 31.9 . This height adjustment is useful for balancing your gimbal on the TRINIPOD. The base of the sled features side-to-side adjustment, and it accepts counterweights, which allow for adjustment to fine-tune the balance of the system for best results. The TRINIPOD features a secure locking system that keeps your gimbal safely mounted.

The TRINIPOD will fit on the arm of any system that uses a 16mm pin, making it compatible with most vest/arm stabilizer support systems.

With a load capacity of nearly 40 lb, the TRINIPOD can help you avoid fatigue by mounting your gimbal and camera setup on an optional vest arm system.

A secure locking system helps prevent your gimbal from unexpectedly detaching from the TRINIPOD.

The sled base features 15mm LWS and allows you to attach a variety of accessories. The included counterweight supports feature 1/4 -20 threaded holes and a cold shoe.

The gimbal support shaft features 1/4 -20 holes for adding accessories.