ARRI BP-9 Bridge Plate Kit with 12' Dovetail Plate & 15mm Rods (17')

This ARRI BP-9 Bridge Plate Kit assembled is used to balance your camera and to support 15mm studio rod-spaced accessories. The kit consists of the BP-9 sled, a 12" bottom dovetail plate, and a 17" pair of 15mm support rods. Directly compatible with the ARRI ALEXA Studio, the Sony F65, and the Phantom Flex4K, the BP-9 Kit can be adapted for use with the ARRI ALEXA, AMIRA, ALEXA Mini, and many third-party cameras (adapters available separately). Unlock the bridge plate lever to easily adjust the camera balance after increasing or decreasing the rig s weight.

The dovetail plate features end posts for security, and it incorporates 3/8" -16 threaded holes for mounting the dovetail on a tripod quick release plate or other support. The hollow pair of 17" rods provides lightweight, standard 15mm rod support for matte boxes, follow focus units, lens supports, and more.

Note:

Not compatible with 15mm LWS-spaced accessories.

ARRI Bridge Plate BP-9

The Bridge Plate BP-9 from ARRI interfaces with a bottom dovetail plate to balance your camera as the weight of the rig is changed (dovetail not included). The BP-8 provides 15mm studio rod support for mounting a lens support and/or accessories onto select ARRI and third-party cameras.

This bridge plate includes 3/8" -16 threaded studs and locating pins for mounting on your camera.

Note:

Not compatible with 15mm LWS-spaced accessories.

Features

Provides 15mm studio rod support for select ARRI and third-party cameras

Helps optimize camera balance

ARRI Bottom Dovetail Plate (12" / 300mm)

Less is more when you re lugging your rig around, so opt for this 12" Bottom Dovetail Plate from ARRI with a weight-reducing cutout design for balancing your camera setup. This updated dovetail offers a medium travel range suitable for prime lenses, and it sports several features that distinguish it from earlier models.

Safety release buttons are located both at the front and back of the dovetail. The front release is especially helpful when using accessories like lens motors that may hang below the level of the baseplate, preventing an easy backward slide off the dovetail. Two removable stopper screws provide additional security when desired and can be parked on the plate when not in use.

Constructed of a robust aluminum alloy, this dovetail has built-in 3/8" -16 and 1/4" -20 threads for mounting on a tripod or quick release plate.

Compatible Heads

Including but Not Limited to:

O Connor 2060, 2575, 120EX
Sachtler Cine 30

Features

Use with a separately available sliding bridge plate or sled to balance your camera rig

Includes safety release buttons on both ends for maximum flexibility

The two removable stopper screws can be stored on the plate when not in use

Both 3/8" -16 and 1/4" -20 threads for mounting on a tripod quick release plate or other support

Robust yet lightweight aluminum alloy build

ARRI 15mm Support Rods (Pair, 17" )

This pair of 17" ARRI Support Rods feature sturdy stainless steel construction and are designed to support heavier loads. Use them with any 15mm-based accessory or bridgeplate.

Hollow, sturdy stainless steel construction with non-threaded ends

Compatible with any 15mm-based accessory or bridgeplate