Miller AIR Toggle LW Alloy System

Miller AIR Fluid Head

The Miller AIR Fluid Head is a lightweight fluid head for the videographer on the go. Designed for cameras between 4.4 and 11 pounds, this die-cast aluminum alloy and rigid composite polymers head is dust and moisture sealed for smooth operation in harsh environments. The sliding camera plate allows 2.36 of balance adjustment, has screw slots, and it comes with a 1/4 -20 and 3/8 -16 camera tie-down screw as well as a combination 1/4-20 screw with locating pin.

Two-steps of counterbalance help you tune the AIR Fluid Head to match the needs of the shot. The fixed pan and tilt drag remains consistent throughout the head s operating temperature range of -40 to 149° F, and each axis has its own independent lock. Featuring a 75mm half-ball leveling base you can use this head with 75mm bowl base tripod legs, or remove the ball leveling stud for flat-base mounting.

Miller fluid head pan and tilt technology

Suitable for payloads between 4.4 to 11 lb

Built for rugged outdoor shooting conditions

Removable stud allows the head to be mounted on a solopod and slider via a 3/8 thread

Optional second pan handle mount

Miller Toggle 75 1-Stage Alloy Tripod (Mid-Level Spreader Ready)

The Miller Toggle 1-Stage Alloy Tripod is designed to be a compact yet sturdy platform for your 75mm ball-base fluid head. The single-stage design allows for a 24.4 to 52.4 height range while maintaining a folded length of 32.7 . Each stage features its own rotary clamp for secure locking, enabling support for payloads up to 55 pounds. Compatible spreaders, rubber feet, and dollies are available separately.

Miller 835 Non-Adjustable Above-Ground Tripod Spreader - for 440 Tripod

A Mid-Level Spreader is chosen when shooting is often performed on uneven surfaces, such as steps, rocky ground, slopes. It allows for rapid set-up and pull down by keeping tripod legs at an equal or preset distance relative to each other. Attaches to the center bracket of a tripod and folds down within tripod without having to take it off.

Speedy set-up for all lightweight tripods

Quick release attachment pins

Integrated in DS5 and DS10 systems with lightweight tripods

Miller 550 Rubber Feet Pads for Select Tripods (Set of 3)

The 550 Tripod Feet from Miller are a set of three rubber snap-on feet designed to be used in any situation where the integrated dual spiked feet are not optimal. They are ideal for use on both slippery and glossy floors. These rubber feet are compatible with all tripods featuring 835 and 508 above ground spreaders.

Miller 874 Soft Tripod Case - for DS 1-Stage Systems (Except with HD Tripod)

The Miller 874 Soft Tripod Case is a padded tripod carry case designed for the Miller DS single stage tripod systems. It has rigid sidewalls sandwiched between high density foam padding and a head-end cradle to protect the tripod and fluid head from heavy bumps during flight and vehicle transport. It has a weatherproof Cordura construction with heavy duty zippers on the bag and the interior pocket. The case is carried by either the padded interlocking carry straps or the padded shoulder strap.

1000 denier water-resistant Cordura fabric

Rigid sidewalls sandwiched between high density EVA foam padding

Head-end cradle protects fluid head from heavy bumps during flight and vehicle transport

Padded interlocking carry straps and padded shoulder strap

1 Interior accessory pocket

Heavy duty zippers on bag and pocket

ID window

Compatible with

• Miller DS single stage system tripod